I've been looking for a new switch for my handle bar for some time since the bike laid down on that side. Its the "right hand switch assembly" and has the run/stop switch plus the starter switch. This part isn't available for purchase anymore, but after several months scouring eBay, I found one for the CB200 (sans T) which is almost the same. It included a high/low beam switch but it doesn't have to be hooked up.
My friend Steve and I spend some time installing the new switch, testing as we went and all seemed good. There were a few wire mismatches (extra wires here and there between the switches, but we got the functionality working before putting it all back together. When we finally did bolt and screw everything back in place again, it no longer worked. There was a short some place.
So I just found a wiring diagram for this bike and we're going to pick it apart and try to figure out where we might be going wrong...
- Installed new handlebar switch